The system cannot find the device specified. The system cannot move the file to a different disk drive. The system cannot find the drive specified. Not enough storage is available to complete this operation. The storage control block address is invalid.Īn attempt was made to load a program with an incorrect format. Not enough storage is available to process this command. The storage control blocks were destroyed. The system cannot find the path specified. The system cannot find the file specified. Therefore we may need to refer you to your IT support depending on the error code and circumstances in which is was generated.
I am not sure if there is a chance that some connection attempt could be blocked while changing the used ACL on the interface but I really doubt it can have a noticiable affect as the ACL is replaced as soon as you issue the "access-group" command with the new ACL.These errors are generated by Microsoft Windows and not by Sage software. To my understanding changing an ACL that is used on the firewall wont affect any active connections through the firewall as those have already been allowed through the firewall. I tested this with my own firewall and it works just fine. Now that the old ACL is removed you can rename the new ACL you made and attached to the interface with the command I mentionedĪccess-list OUTSIDE-IN-1 rename OUTSIDE-IN I would suggest that you backup the original ACL just incase if there is some error in the new ACL so you can compare it original one. You can now use this command to remove that ACL completely from the ASA This ACL is the one that has the wrong "remark" that you are trying to remove. Now doing the above should mean that you now have the old OUTSIDE-IN ACL on the ASA but its not attached anywhere. This will replace any ACL that is currently attached to that interface.Īccess-group OUTSIDE-IN-1 in interface outside The below command would essentially attach the below named ACL to the interface called "outside". Now that you have your new ACL with corrected "remark" configured you can replace the old ACL (identical ACL, except for the corrected information) with the new one Now you could copy/paste that to notepad and simply change it to ( -1 added to the name and changed "remark")Īccess-list OUTSIDE-IN-1 remark Permit some trafficĪccess-list OUTSIDE-IN-1 permit ip host 1.1.1.1 host 2.2.2.2 (It shows the hitcounts etc.)Īccess-list OUTSIDE-IN remark äöäöäöäöäöäĪccess-list OUTSIDE-IN permit ip host 1.1.1.1 host 2.2.2.2 The command "show access-list " does show the ACL but it shows it in a format that you can't directly copy paste back to the device. You can view the ACL in its configuration format with the command "show run access-list ". You can just copy the current ACL to notepad and modify the remarks and any other sections you need to and then simply replace the ACLs name with something else than the current one.
Well you should be able to do it pretty easily.
0 kommentar(er)
